NOTE: Read entire instruction sheet before you start installation and assembly.
WARNING
•Do not begin to install your Peerless product until you have read and understood the instructions and warnings con- tained in this Installation Sheet. If you have any questions regarding any of the instructions or warnings, call Peerless customer care at
•This product should only be installed by someone of good mechanical aptitude, has experience with basic building construction, and fully understands these instructions.
•Make sure that the supporting surface will safely support the combined load of the equipment and all attached hard- ware and components.
•Never exceed the Maximum Load Capacity.
•Always use an assistant or mechanical lifting equipment to safely lift and position equipment.
•Tighten screws firmly, but do not overtighten. Overtightening can damage the items, greatly reducing their holding power. See suggested torque values where applicable within these instructions.
•This product is intended for indoor use only. Use of this product outdoors could lead to product failure and personal injury.
| CAUTION |
|
| • It is the responsibility of the installer to ensure that the |
|
| projector is properly ventilated. |
|
Tools Needed for Assembly |
| |
• | stud finder ("edge to edge" stud finder is recommended) |
|
• | phillips screwdriver |
|
• | drill |
|
• | 1/4" bit for concrete surface |
|
• | 5/32" bit for wood studs |
|
• | open end wrench |
|
• | level |
|
Table of Contents |
| |
Parts List | 3 | |
Installation to Extension Columns / Ceiling Plate | 4 | |
Installation to Wood Joist Ceilings | 5 | |
Installation to Concrete Ceilings | 6 | |
Installation to Threaded Rods | 7 | |
Attaching Adapter Plate to Projector | 8 | |
Attaching Adapter Plate to Projector Mount | 9 | |
Projector Alignment | 10 | |
| 2 of 10 | ISSUED: |
Visit the Peerless Web Site at www.peerlessmounts.com | For customer care call |
