Installation To Wood Joist Ceilings
WARNING
•Tighten wood screws so that projector mount assembly is firmly attached, but do not overtighten. Overtightening can damage the screws, greatly reducing their holding power.
•Never tighten in excess of 80 in • lb (9 N.M.).
•Make sure that mounting screws are anchored into the center of the studs. The use of an "edge to edge" stud finder is highly recommended.
2 | Place projector mount assembly (A) on ceiling as a template and mark the center of the two mounting holes. Make | ||
sure that the mounting holes are in the center of the wood joist. Drill two 5/32" (4 mm) dia. holes to a minimum | |||
| depth of 2.5" (64 mm). Attach projector mount assembly (A) with two #14 x 2.5" (6 mm x 65 mm) wood screws (F) | ||
| and two flat washers (E) as shown in figure 2.4 or figure 2.5 depending on joist orientation. Tighten wood screws (F) | ||
| using 3/8" (10 mm) socket wrench, phillips screwdriver or 10mm open end wrench until projector mount | ||
| assembly (A) is firmly attached. |
|
|
| Skip to step 3. |
|
|
|
| ACCESS SLOT FOR |
|
|
| OPEN END WRENCH |
|
|
| ALLOWS TIGHTENING |
|
| WOOD JOIST | OF WOOD SCREW (F) | WOOD JOIST |
| WITHOUT REMOVING | ||
|
| ||
|
| PROJECTOR |
|
|
|
| FRONT OF |
|
|
| MOUNT |
A
E
F
FRONT OF MOUNT
A
E
F
fig. 2.4 | fig. 2.5 |
5 of 10 | ISSUED: |
Visit the Peerless Web Site at www.peerlessmounts.com | For customer care call |
