Projector Alignment
7 | To adjust yaw (swivel) for wood stud, concrete ceiling, and threaded rod mounting applications: |
Loosen wood screws (F) if flush mounted to wood joists (page 5) or concrete ceilings (page 6), or loosen |
locknuts on threaded rods (page 7), until projector mount can be rotated. Rotate mount to desired position and retighten screws or locknuts.
To adjust yaw (swivel) for extension column applications: Loosen screw on projector mount assembly (A) indicated below until projector mount can be rotated. Rotate mount to desired position and retighten screw.
To adjust pitch (forward and backward tilt): Turn knob on back of mount as shown below. Pull knob out and turn by hand for easy adjustment or insert #2 phillips screwdriver in end of knob and turn.
To adjust roll (side to side tilt): Turn knob on side of mount as shown below. Pull knob out and turn by hand for easy adjustment or insert #2 phillips screwdriver in end of knob and turn.
ARROW INDICATES
FRONT OF MOUNT
ACCESS SLOT FOR
OPEN END WRENCH
ALLOWS TIGHTENING
OF WOOD SCREW (F)
WITHOUT REMOVING
PROJECTOR
SCREW FOR YAW (SWIVEL) STOP (REFER TO STEP 2, INSTALLATION TO EXTENSION COLUMNS, FIG. 2.3)
A
KNOBFORPITCH
ADJUSTMENT
BACK OF MOUNT
KNOB FOR ROLL
ADJUSTMENT
Note: Tighten screws firmly, but do not overtighten. Overtightening can damage the mount.
CAUTION
•Do not adjust pitch or roll while tamper resistant security screws are fully engaged.
•Loosen the two tamper resistant security screws one complete turn before adjusting the projector mount assembly or damage may occur.
TOLOCKPITCHTIGHTEN
TAMPER RESISTANT
SECURITY SCREW
SIDE VIEW
10 of 10 | ISSUED: |
Visit the Peerless Web Site at www.peerlessmounts.com | For customer care call |
© 2008, Peerless Industries, Inc. All rights reserved. All other brand and product names are trademarks or registered trademarks of their respective owners.
