NEC NP400G  Part Names of the Projector, Front/Top, Rear, Introduction, Zoom Lever → page, Lens

1. Introduction

Part Names of the Projector

Front/Top

Zoom Lever (→ page 27)

Focus Ring
(→ page 27)
Remote sensor	SU	FOC
(→ page 8)

Controls

(→ page 5)

Security chain opening -theft device.

The security chain opening accepts se- curity wires or chains up to 0.18 inch/ 4.6 mm in diameter.

Lens	Built-in Security Slot ( )*
	Ventilation (inlet) / Filter Cover
Lens Cap	(→ page 70)
	Adjustable Tilt Foot Lever (→ page 26)
	Adjustable Tilt Foot (→ page 26)

*This security slot supports the MicroSaver ® Security System.

Rear

Ventilation (inlet) / Filter Cover (→ page 70)

Terminal Panel (→ page 6)

Lamp Cover (→ page 72)

FOCUS

Monaural Speaker (7W)

Ventilation (outlet)

Heated air is exhausted from here.

Spacer (black rubber)

To fine-adjust the height of the rear foot, remove the spacer and rotate the rear foot to the desired height.

Rear Foot (→ page 26)

AC Input

Connect the supplied power cable’s two-pin plug here, and plug the other end into an active wall outlet. (→ page 21)

Main Power Switch

When you plug the supplied power cable into an active wall outlet and turn on the Main Power, the POWER indicator turns orange and the projector is in standby mode.

(→ page 22,32)