4. Convenient Features
2.Press the SELECT button.
The area of the magnified image will be moved
3. Press the MAGNIFY (-) button.
Each time the MAGNIFY
NOTE:
•The image will be enlarged or reduced at the center of the screen.
•Displaying the menu will cancel the current magnification.
OFF | ON |
POWER |
|
MAGNIFY | PAGE |
| UP |
| DOWN |
MENU |
|
ENTER | EXIT |
Changing Lamp Mode
This feature enables you to select two brightness modes of the lamp:
Normal and Eco modes. The lamp life can be extended by using the Eco mode.
Lamp Mode | Description | Status of LAMP indicator |
|
| |
|
|
|
|
|
|
NORMAL | This is the default setting (100% | Off | LAMP | ||
|
| ||||
| Brightness). |
|
| STATUS | |
|
|
|
|
|
|
|
|
|
| ||
ECO | Select this mode to increase the | Steady Green light |
|
| LAMP |
| lamp life (approx. 80% Brightness). |
|
|
| STATUS |
|
|
|
| ||
|
|
|
|
|
|
To change to the [ECO] mode, do the following:
1.Press the LAMP MODE button on the remote control to display [LAMP MODE] screen.
2.Use the SELECT or button to select [ECO] mode.
3.Press the ENTER button.
To change from [ECO] to [NORMAL], Go back to Step 2 and select [NORMAL]. Repeat Step 3.
NOTE:
•The LAMP MODE can be changed by using the menu. Select [SETUP] → [GENERAL] → [LAMP MODE].
•The lamp life remaining and lamp hours used can be checked in [USAGE TIME]. Select [INFO.] →[USAGE TIME].
•The projector is always in [NORMAL] for one minute after the lamp is turned on and while the POWER indicator is blinking green. The lamp condition will not be affected even when [LAMP MODE] is changed.
•After a lapse of 3 minutes from when the projector displays a blue, black or logo screen, [LAMP MODE] will automatically switch to [ECO]. The projector will return to the [NORMAL] once a signal is accepted.
•If the projector is overheated in [NORMAL] mode, there may be a case where the [LAMP MODE] automatically changes to [ECO] mode to protect the projector. When the projector is in [ECO] mode, the picture brightness decreases. When the projector comes back to normal temperature, the [LAMP MODE] returns to [NORMAL] mode.
Thermometer symbol [ 
] indicates the lamp mode is automatically set to [ECO] mode because the internal temperature is too high.
35
