NEC NWA-008862-001 manual Requirements on PBX Side, Connect the modem to your PC, Name, Remarks

CHAPTER 1 MATWorX

2. Hardware Connections

1.Connect the modem to your PC.

2.To use a built-in modem, set the SW2-4 of the MP card to ON.

3.Mount the COT card in the system.

4.Set up the MATWorX and establish the communication setting (Modem Connect) between your PC and the PBX using Configuration Wizard.

5.Set the following system data:

CM40 Y=10>1:⋅-⋅⋅⋅⋅⋅⋅⋅⋅ (station number) CM13 Y=07>⋅-⋅⋅⋅⋅⋅⋅⋅⋅ (station number):0

NOTE: When using the built-in modem in the PBX, RS1 port of the MP card cannot be used.

The requirements on the PBX side are shown below.

Requirements on PBX Side

Name	qt.	Remarks
COT card	1	Used for interface
		between the PBX and
		public network

NWA-008862-001 Rev.2.1	Page 9
ajch1001.fm