Installation instructions
Outdoorunitinstallation
1.Install Drain Port and Drain Hose (for
The condensate drains from the outdoor unit when the unit operates |
|
|
in heating mode. In order not to disturb your neighbor and protect |
|
|
the environment, install a drain port and a drain hose to direct the |
|
|
condensate water. Just install the drain port and rubber washer to |
|
|
the chassis of the outdoor unit, then connect a drain hose to the |
| Washer |
port as the right figure shown. | Drain port | Drain hose |
| ||
2. Install and Fix Outdoor Unit |
| (prepare by user) |
|
| |
Fix with bolts and nuts tightly on a flat and strong floor. |
|
|
If installed on the wall or roof, make sure to fix the supporter well to prevent it |
| |
from shaking due to serious vibration or strong wind. |
|
|
3. Outdoor Unit Piping Connection |
|
|
Remove the valve caps from the
Connect the pipes to the
4. Outdoor Unit Cable Connection (see previous page)
Airpurging
The air which contains moisture remaining in the refrigeration cycle may cause a malfunction on the compressor. After connecting the indoor and outdoor units, evacuate air and moisture from refrigerant cycle using a vacuum pump, as shown below.
Vacuum pump
indoor unit
Service port
(2)Turn
(8)Tighten
Refrigerant flow direction | ||
| ||
| ||
|
|
connect to indoor unit
(6) Open 1/4 turn
(7) Turn to fully open the valve
(1) Turn
Valve cap | (8) Tighten |
(7)Turn to fully open the valve valve cap
(1) Turn
(8) Tighten
Connect to outdoor unit
Valve core
open position spindle
needle
service port cap
Note: To protect the environment, be sure not to discharge the refrigerant to the air directly.
21
PDF created with pdfFactory Pro trial version www.pdffactory.com