NEC XP29, XM29 Plus, XP29 Plus, XM29 Plus DOC compliance Notice, Warnings and Safety Precaution

Models: XP29 Plus, XM29 Plus XP29, XM29 Plus

1 40
Download 40 pages 52.47 Kb
Page 2
Image 2
DOC compliance Notice

CAUTION

RISK OF ELECTRIC SHOCK

DO NOT OPEN

CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER. NO USER-SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.

This symbol warns the user that uninsulated voltage within the unit may have sufficient magnitude to cause electric shock. Therefore, it is danger- ous to make any kind of contact with any part inside of this unit.

This symbol alerts the user that important literature concerning the opera- tion and maintenance of this unit has been included. Therefore, it should be read carefully in order to avoid any problems.

WARNING

TO PREVENT FIRE OR SHOCK HAZARDS, DO NOT EXPOSE THIS UNIT TO RAIN OR MOISTURE. ALSO DO NOT USE THIS UNIT'S POLARIZED PLUG WITH AN EXTENSION CORD RECEPTACLE OR OTHER OUTLETS, UNLESS THE PRONGS CAN BE FULLY INSERTED. REFRAIN FROM OPENING THE CABINET AS THERE ARE HIGH-VOLTAGE COMPONENTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.

DOC compliance Notice

This Class A digital apparatus meets all requirements of the Canadian Interference-Causing Equipment Regulations.

WARNING

This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at his own expense.

Warnings and Safety Precaution

The NEC MultiSync Multimedia monitors XP29 Plus and XM29 Plus are designed and manufactured to provide long, trouble-free service. No maintenance other than cleaning is required. Use a soft cloth and if necessary, mild detergent. Do not use commercial spray cleaners which may damage the surface. In case of damage, arrange for re- pairs at an authorized NEC Service Center.

For operating safety and to avoid damage to the unit, read carefully and observe the following instructions.

To avoid shock and fire hazards:

1.Provide adequate space for ventilation to avoid internal heat build- up. Do not cover rear vents or install in a closed cabinet or shelves. The unit is equipped with cooling fans on the top. If you enclose the unit in a cabinet or rack, be sure there is adequate space at the top of the unit to allow heated air to rise and escape. A cabinet or shelves in which the unit is placed must be maintained below 40°C

2.Do not use the power cord polarized plug with extension cords or outlets unless the prongs can be completely inserted.

3.Do not expose unit to rain or moisture.

4.Avoid damage to the power cord, and do not attempt to modify the power cord.

5.Unplug unit during electrical storms or if unit will not be used over a long period.

6.Do not open the cabinet which has potentially dangerous high volt- age components inside. If the unit is damaged in this way the war- ranty will be void. Moreover, there is a serious risk of electric shock.

7.Do not attempt to service or repair the unit. NEC is not liable for any bodily harm or damage caused if unqualified persons attempt ser- vice or open the back cover. Refer all service to authorized NEC Ser- vice Centers.

To avoid damage and prolong operating life:

1.Use only with 100-120V/220-240V 50/60Hz AC power supply. Contin- ued operation at line voltages other than 100-120V/220-240 Volts AC will shorten the life of the unit, and might even cause a fire hazard.

2.Handle the unit carefully when moving and do not drop.

3.Locate set away from heat, excessive dust, and direct sunlight.

4.Protect the inside of the unit from liquids and small metal objects. In case of accident, unplug the unit and have it serviced by an autho- rized NEC Service Center.

5.Unplug unit before cleaning. Use only a soft cloth and mild detergent. Commercial household sprays and cleaners may damage the CRT surface and cabinet.

6.Stacking of units, one top of another, may result in damage to the units. Stacking is not recommended.

Page 2
Image 2
NEC XP29, XM29 Plus, XP29 Plus, XM29 Plus user manual DOC compliance Notice, Warnings and Safety Precaution