3
Part Names and Functions
Front View | Rear View |
9 8 7 6 5 4
Multisync
3 2 1
POWER
/STANDBY
0
Terminal Board
1 POWER | Press to turn the main power on and off when | ||
|
|
| the AC power is supplied. |
|
| ||
2 STANDBY/POWER |
| ........ | When this indicator is green, the monitor is |
| |||
|
|
| on; when the indicator is red, it is in standing |
|
|
| by. |
3 Remote Sensor Window ... | Receives infrared signal from the handheld | ||
|
|
| remote control. |
4 RGB 2/+ | Press to select an RGB video source that is | ||
|
|
| connected to the RGB 2 input terminals (BNC |
|
|
| type). When you are in the OSM mode, this |
|
|
| button works as the plus button. |
5 RGB | Press to select an RGB video source that is | ||
|
|
| connected to the RGB 1 input terminal (D- |
|
|
| SUB 15 pin type). |
|
|
| When you are in the OSM mode, this button |
|
|
| works as the minus button. |
6 VIDEO 2/ | Press to select an NTSC, PAL, SECAM or M- |
| NTSC compatible video source that is |
| connected to the VIDEO 2 input terminal (BNC |
| type or |
| OSM mode, this button works as the up button. |
|
|
| NOTE: |
| preference over VIDEO IN terminals when |
| the video source is connected to each |
| terminal and VIDEO 1 or 2 selected. |
.........................7 VIDEO 1/ | Press to select an NTSC, PAL, SECAM or M- |
| NTSC compatible video source that is |
| connected to the VIDEO 1 input terminal (BNC |
| type or |
| OSM mode, this button works as the down |
| button. |
8 EXIT | Press to exit the OSM mode. The OSM screen |
| disappears. |
9 PROCEED | Press to access OSM. The OSM screen is |
| displayed. |
0 Remote Control Holder ..... Place remote control unit here when not in
use.
4