ON
ON
↑�
1 | 2 | 3 | 4 | 5 | 6 | 7 | 8 | OFF |
17
Functions and Settings of DIP SW
This DIP switch is used for Sync. Control, Intelligent Power Manager, External control, wireless control, and OSM control. To change a switch setting use a pointed object, such as a pen or pencil, to push the switch to the desired position.
Set all the pins except No.7 to the OFF position during normal operation. The pins nos 2,3 and 5 are not used.
Pin No 1(Sync. Control )
The No. 1 pin set Sync. Control.
Set the No. 1 pin to the OFF position during normal operation. The monitor automatically determines if the input signal is separate sync, composite sync or sync on green signal in this order.
Set the No. 1 pin to the ON position when sync on green signals are necessary for synchronization with an external component.
Pin No. 4 (Intelligent Power Manager)
This function saves power.
When Intelligent Power Manager control is on, by using the monitor’ s horizontal and vertical SYNC signals, the monitor can be prompted into the different IPM modes. The following is the description of the LED indicator for the IPM power saving modes:
Mode | LED Indicator | Power Saving |
On | Green | None |
|
|
|
Standby | Red (Steady) | None |
Standby | Amber(Blinking quickly) | Minimum |
State |
| (Quickest recovery) |
|
|
|
Suspend | Amber(Blinking moderately) | Moderate |
State |
| (Moderate recovery) |
|
|
|
Off State | Amber(Blinking slowly) | Maximum |
|
| (EPA<8 watts, Slowest recovery) |
|
|
|
Power Off | No Light | No Power Used (Fully Off) |
|
|
|
|
|
|
NOTE: The Intelligent Power Manager works only for the RGB input. If selecting the VIDEO input, or when connecting to no signal source, the Intelligent Power Manager does not work.
Pin No. 6 (EXT. CONTROL)
When this switch is set to ON, the External Control function is activated. See page 46 for pin assignments.
Pin No. 7 (REMOTE ON/OFF)
When this switch is set to ON, the monitor can be controlled by the wireless remote control unit.If you have some monitors you do not want to control by remote, set to OFF.
Pin No. 8 (OSM System Control Menu ON/OFF)
When this switch is set to ON, the system control menu is displayed. In this menu the following features are enabled:
Power on mode set(POWER ON MODE)
Front control key on/off(FRONT CONTROL)
Language selection(LANGUAGE)
Video mode(auto/manual) selection(VIDEO MODE)
OSM on/off(OSM ON/OFF)
CONVERGENCE SETUP
For the setting procedures to set the items, see pages 43 to 45.
18
14