E – 32
Color Matrix
First, select an appropriate color matrix for your input signal, either
HDTV or SDTV. Then select an appropriate matrix type from B-Y/R-
Y, U/V, Cb/Cr, Pb/Pr or IVX.

NOTE: The Color Matrix feature is available for component video signal only.

Y/C Delay (not available for RGB)
Adjusts Y/C delay level.
Telecine
Use 3:2 pull down correction to eliminate jitter and artifacts in video.
Auto .............For film source such as a DVD player
Off................ For signals other than film sources
Motion Select:
Sets the interpolation method. Selects Still or Adaptive. Still is used
for non moving images such as a document camera. Select Adapter
for all motion video.
Motion Level
Adjusts level of motion detection when Adaptive is selected.
YTR Adjustmen (not available for RGB)
Adjusts luminance transient time.
CTR Adjustment (not available for RGB)
Adjusts chroma transient time.
Option Adj
According to the signal, this function sets the detection position (i.e.,
clamp position) of the black level reproduction of the analog input
signal. Normally this is not used.
Auto .............This is the normal setting.
Tri-Sync .......This is set when projecting HDTV video.
Front Porch.. This is set when the picture quality does not improve even
though Auto or Tri-Sync has been set.
Adjust ..........This permits the video clamp position for each signal to be
set. Use "Adjust" when a clamp timing error occurs at the time
of special analog signal reception such as 1080P. Note that
"Adjust" is not valid for doubler signals such as NTSC and
PAL.
Sync Protection
When a VCR, DVD, or some other equipment that supports
Copyguard (a copy prevention system) is played back, the screen
may be displayed in a curved manner. Adjustments are made in
such circumstances. Use the SELECT 䊴 or 䊳 button to adjust the
Upper of Lower levels.
VD Delay
This feature is used to correct vertical jitter of non-standard inter-
laced signal. Select one of the three VD delay levels.

NOTE: When connecting with a scan converter:

If an image from the scan converter is not correctly displayed, adjust to

select the best level point so that the image is displayed correctly.

Clamp Timing: