NETGEAR DM111PSPv2 user manual Outbound IP Filtering Rule Settings, Settings Description

ADSL2+ Modem Router DM111PSPv2 User Manual

Outbound Firewall Traffic Rules

When the Outbound Traffic radio button is selected and you click Add in the Firewall Rules screen (see Figure 3-1 on page 3-3), the Add New Outbound IP Filtering Rule screen displays (see following page).

Figure 3-2

Create a new outbound IP filtering rule, and then click Apply to add the rule to the outbound traffic rules table in the Firewall Rules screen (see Figure 3-1 on page 3-3). Table 3-1describes the settings on the Add New Outbound IP Filtering Rule screen.

Table 3-1. Outbound IP Filtering Rule Settings

Settings	Description
Allow Traffic	Select a radio button
	• Yes. The new rule is used to allow outbound traffic.
	• No. The new rule is used to prevent outbound traffic
Protocol	Make a selection from the drop-down list:
	• TCP. The rule applies to Transmission Control Protocol (TCP) traffic.
	• UDP. The rule applies to User Datagram Protocol (UDP) traffic.
	• ICMP. The rule applies to Internet Control Message Protocol (ICMP) traffic.
	• AH. The rule applies to Authentication Header (AH) protocol traffic.
	• ESP. The rule applies to Encapsulating Security Payload (ESP) traffic.
	• GRE. The rule applies to Generic Route Encapsulation (GRE) traffic.
	• ALL. The rule applies to all protocol traffic.
	• User Defined. Enter a protocol name in the “as” field.

3-4 Security and Firewall Protection

v1.0, December 2008