NETGEAR FS526Tv2 Support, Trademarks, Revision History

2

ProSAFE 26-Port Fast Ethernet Smart Switch FS526Tv2

Support

Thank you for selecting NETGEAR products.

After installing your device, locate the serial number on the label of your product and use it to register your product

at https://my.netgear.com. You must register your product before you can use NETGEAR telephone support.

NETGEAR recommends registering your product through the NETGEAR website. For product updates and web

support, visit http://support.netgear.com.

Phone (US & Canada only): 1-888-NETGEAR.

Phone (Other Countries): Check the list of phone numbers at

http://support.netgear.com/general/contact/default.aspx.

Trademarks

NETGEAR, the NETGEAR logo, and Connect with Innovation are trademarks and/or registered trademarks of

NETGEAR, Inc. and/or its subsidiaries in the United States and/or other countries. Information is subject to change

without notice. © NETGEAR, Inc. All rights reserved.

Revision History

Publication

Part Number Publish Date Comments

202-11251-02 July 2013

202-11251-01 June 2013 First publication

• Added information about the product label

• Replaced references to the Software Administration Manual with

references to the web management user guide

Contents

Main ProSAFE 26-Port Fast Ethernet Smart Switch FS526Tv2 Support Trademarks Revision History Contents Chapter 1 Introduction and Hardware Description Appendix A Physical and Technical Specifications Chapter 2 Installation Chapter 3 Troubleshooting Description Overview Switch Features Package Contents Front Panel Back Panel Introduction and Hardware Description ProSAFE 26-Port Fast Ethernet Smart Switch FS526Tv2 LEDs The following table describes the LEDs. Figure 5. Generic product label Product Label Table 1. LED descriptions RJ-45 Ports Factory Defaults Button and Reset Button Page Installation ProSAFE 26-Port Fast Ethernet Smart Switch FS526Tv2 Step 1: Prepare the Site Table 2. Site requirements Step 2: Install the Switch You can install the switch on a flat surface or in a standard 19-inch rack. Install the Switch on a Flat Surface Install the Switch in a Rack Step 3: Check the Installation Step 4: Connect Devices to the Switch Step 5: Apply AC Power Step 6: Manage the Switch through a Web Browser or through the Smart Control Center Page Troubleshooting Troubleshooting Chart The following table lists symptoms, causes, and solutions of possible problems. Table 3. Troubleshooting chart Troubleshooting Suggestions Network Adapter Cards Page A Table 4. Physical and technical specifications Physical and Technical Specifications Table 4. Physical and technical specifications (continued)