GS716T/GS724T Hardware Installation Guide
Physical Description 2-7
v1.0, January 2011

• System LEDs

Figure 2-4 illustrates the NETGEAR GS724T Smart Switch back panel:

The back panel contains the following:

• A 100-240VAC/50-60 Hz universal input, which is a standard AC power receptacle for

accommodating the supplied power cord.

LED Designations

Port LEDs

The following table describes the port LED designations.

Figure 2-4
Table 2-1. Port LEDs
Port LED Designation
16/24-10/100/1000 Mbps
Ports - 3 LEDs per port LINK/ACT
SPD
FDX
•Solid Green - A valid 1000 Mbps link is
established on the port.
•Flashing Green - Packet transmission or
reception is occurring on the port at
1000 Mbps.
•Solid Yellow - A valid 10/100 Mbps link is
established on the port.
•Flashing Yellow - Packet transmission or
reception is occurring on the port at 10/
100 Mbps.
•Off - No 10/100 Mbps link is established on
the port.
•Solid Green - Full-duplex link is established
on the port.
•Off - No full-duplex or half-duplex link is
established on the port.
RS-232 Power Connector