Reference Manual for Cable/DSL Wireless Router WGR614

Disable. No encryption will be applied. This setting is useful for troubleshooting your wireless connection, but leaves your wireless data fully exposed.

64-bit or 128-bit WEP. When 64-bit or 128-bit is selected, WEP encryption will be applied.

If WEP is enabled, you can manually or automatically program the four data encryption keys. These values must be identical on all PCs and access points in your network.

There are two methods for creating WEP encryption keys:

Passphrase. Enter a word or group of printable characters in the Passphrase box and click the Generate button. These characters are case sensitive.

Manual. For 64-bit WEP, enter 10 hexadecimal digits (any combination of 0-9, a-f, or A-F). For 128-bit WEP, enter 26 hexadecimal digits (any combination of 0-9, a-f, or A-F). These values are not case sensitive.

Default Factory Settings

When you first receive your WGR614, the default factory settings are shown below. You can restore these defaults with the Factory Default Restore button on the rear panel. After you install the WGR614 router, use the procedures below to customize any of the settings to better meet your networking needs.

FEATURE

DEFAULT FACTORY SETTINGS

 

 

Wireless Access Point

Enabled

 

 

Wireless Access List (MAC Filtering)

All wireless stations allowed

 

 

SSID broadcast

Enabled

 

 

SSID

NETGEAR

 

 

11b/g RF Channel

11

 

 

Mode

g and b

 

 

Authentication Type

Open System

 

 

WEP

Disabled

 

 

3-6

Wireless Configuration

Page 40
Image 40
NETGEAR NTGWGR614 manual Feature Default Factory Settings