NETGEAR WNHDE111 5GHz Restoring the Default User Name and Password, Interface Specifications

WNHDE111 5GHz Wireless-N HD Access Point/Bridge User Manual

Table A-1. Wireless-N AccessPoint/Bridge Default Configuration Settings

Feature		Default Setting
Electromagnetic Emissions
	Meets requirements of	FCC Part 15 Class B
		VCCI Class B
		EN 55 022 (CISPR 22), Class B
		C-Tick N10947 ???
Interface Specifications
	LAN	10BASE-T or 100BASE-Tx, RJ-45
	Internet	10BASE-T or 100BASE-Tx, RJ-45
	Wireless	Maximum wireless signal rate complies with the IEEE
		802.11 standard. Actual throughput will vary. Network
		conditions and environmental factors, including
		volume of network traffic, building materials and
		construction, and network overhead, lower actual
		data throughput rate.
	Radio Data Rates	1, 2, 5.5, 6, 9, 12, 18, 24, 36, 48, 54, and 108 Mbps
		Auto Rate Sensing ???
	Frequency	???
	Data Encoding	802.11n: ???
		802.11a: ???
	Maximum Computers Per Wireless	Limited by the amount of wireless network traffic
	Network	generated by each node. Typically 30–70 nodes.
	Operating Frequency Ranges	?
	802.11 Security	40 bit (also called 64 bit) and 128 bit WEP, WPA-PSK
		and WPA2-PSK.

Restoring the Default User Name and Password

You can restore the factory default configuration settings to reset the bridge’s user name to admin, the password to password, and the IP address to 192.168.0.100. This procedure erases your current configuration, including your wireless security settings, and restores the factory defaults. When you log in after resetting, the Smart Wizard configuration assistant prompts you to configure these settings.

Technical Specifications A-3

v1.1, May 2008