NETGEAR WPN802 manual Chapter Basic Installation and Configuration, Default Factory Settings

Chapter 3

Basic Installation and Configuration

This chapter explains how to install and configure and the WPN802 Access Point on your network. The first time you configure the WPN802 Access Point it must be connected with an Ethernet cable to a computer with a broadband Internet connection.

Default Factory Settings

The WPN802 default factory settings are shown below. After you install the WPN802 Access Point, customize any of the settings to better meet your networking needs.

FEATURE	DEFAULT FACTORY SETTINGS
User Name (case sensitive)	admin
Password (case sensitive)	password
Operating Mode	Access Point
Access Point Name	netgearxxxxxx where xxxxxx are the last six digits of
	the wireless access point’s MAC address
Built-in DHCP client	DHCP client disabled
SIP Configuration	IP Address: 192.168.0.231
(if DHCP server is unavailable)	Subnet Mask: 255.255.255.0
	Gateway: 0.0.0.0
Network Name (SSID)	NETGEAR
Broadcast Network Name (SSID)	Enabled
802.11b/g RF Channel	6
Mode	Auto 108
AutoCell Enhanced RF Security ‘stealth’ mode	Disabled
WEP/WPA	Disabled
Restricting connectivity based on MAC Access	Disabled
Control List

Basic Installation and Configuration 3-1

202-10101-01, 4 May 2005