Reference Manual for the NETGEAR RangeMax™ Wireless Access Point WPN802
System Requirements
Before installing the WPN802, make sure your system meets these requirements.
•A 10/100 Mbps Local Area Network device such as a hub, router, or switch.
•The Category 5 UTP straight through Ethernet cable with
•A
•A Web browser for configuration such as Microsoft Internet Explorer 6.0 or above, or Netscape Navigator 4.78 or above.
•At least one computer with the TCP/IP protocol installed.
•802.11b or
Prepare to Install Your Wireless Access Point
•Observe the wireless placement and range guidelines in “Observe Performance, Placement, and Range Guidelines” on page
•For Cable Modem Service: When you perform the wireless access point setup steps be sure to use the computer you first registered with your cable ISP.
•For DSL Service: You may need information such as the DSL login
•Familiarize yourself with the contents of the Resource CD for the NETGEAR WPN802 RangeMax™ Wireless Access Point
First, Connect the Wireless Access Point to Your Computer
Before installing the wireless access point, make sure that your Ethernet network is up and working.
1.Prepare a computer with Internet access and an Ethernet adapter. If this computer is already part of your network, record its TCP/IP configuration settings.
Basic Installation and Configuration |