Network Technologies DVI-4 Using the Unimux USB KVM Switch, Front Panel Control, Keyboard Control

NTI UNIMUX SERIES USB DVI KVM SWITCH

USING THE UNIMUX USB KVM SWITCH

Once the UNIMUX is properly connected, the UNIMUX will enable a connection to be made between the CPUs attached to its VIDEO and CPU ports and the monitor and input devices attached to the MONITOR and DEVICES ports. The LEDs on the control panel of the UNIMUX will illuminate depending on which port (and corresponding CPU) is being connected to the monitor and input devices.

The UNIMUX can be controlled by two methods:

•front control panel using touch-switches and LEDs

•keyboard control through Command Mode

Front Panel Control

There is a touch-switch and LED on the front panel of the UNIMUX for each CPU the switch will connect the monitor and input devices to. Pressing any touch-switch on the front panel of the UNIMUX will connect the corresponding CPU to the monitor and input devices.

Holding down any front panel touch-switch for more than 2 seconds will cause the UNIMUX to cycle through all modes of operation including COMMAND, BROADCAST, SCAN, and NORMAL (described in "Command Mode" below). The three MODE LEDs on the front panel indicate which mode is selected. Release the touch-switch when the LEDs indicate the desired mode. When no mode LEDs are illuminated the user is in Normal Mode controlling directly the CPU to which the user is connected through the UNIMUX.

Keyboard Control

Keyboard control of the UNIMUX can be achieved using Command Mode (below). The keyboard can be used to control all functions of the UNIMUX as an alternative to using the front panel on the UNIMUX.

By pressing <Ctrl> + < ` > (accent key), the user can enter Command Mode. Once in Command Mode, typing a series of commands will cause the UNIMUX to connect the user to any one CPU connected to the switch. Pressing the <Esc> key will exit Command Mode.

Command Mode

In order to control the UNIMUX with the keyboard connected, Command Mode must be enabled. To enter Command Mode from

the keyboard:	Ctrl	+	~	(ACCENT
Press
			`	KEY)

When the COMMAND LED is illuminated, all 3 status lights on the keyboard will illuminate (if they aren't already due to caps lock, scroll lock, and/or num lock) to indicate that Command Mode is enabled and the following functions are available:

Basic Command Functions
Function:	Keystroke:
Increment Port		I	or			(select the next higher port
						ex. 03	04)
		D	or			(select the next lower port
Decrement Port						ex. 02	01)
Toggle Scan Mode		S	(The SCAN Mode LED will
ON and OFF			also toggle ON and OFF)
Toggle Broadcast Mode			(The Broadcast Mode LED
		B will toggle ON and OFF.)
ON and OFF
Sets scan time-out		T	-	(0-2)	-	(0-9)		-	(0-9)
period for each port.				x		x			x

	KEY SYMBOLS LEGEND:
or	PRESS EITHER KEY
+	CHORDED SEQUENCE- PRESS CONSECUTIVELY
	AND KEEP KEYS PRESSED UNTIL ALL ARE PRESSED.
-	PRESS CONSECUTIVELY

(xxx from 002 to 255. ie. T002 would set the time-out period for 2 seconds)

8