![](/images/new-backgrounds/1109556/10955625x1.webp)
NTI RACKMUX KVM Drawer with NODEMUX Switch
Administration Mode (Cont'd) |
|
|
|
|
|
|
|
Function: | Keystroke: |
|
|
|
|
|
|
Selects the idle time in minutes | T - | - | - | (xxx from 000 to 255. i.e. T002 | |||
would set the | |||||||
| x | x | x | for 2 minutes. 000 will disable it) | |||
Exit Administration Mode and |
|
|
|
|
|
|
|
return to previous mode | Esc |
|
|
|
|
|
|
Switch Configuration
Switch Configuration enables the administrator to configure the NODEMUX to be used as a stand alone switch or as one of the switches in a cascaded system. Switch Configuration is also used to setup the communication settings for RS232 communication with a remotely connected terminal through the RS232 port.
Note: When used in a RACKMUX, the NODEMUX can only be used as a stand alone switch. Do not change this setting.
In the event the setting is changed from "stand alone" to "slave", when the switch is power cycled the OSD menu will no longer work. To change it back to a "stand alone" switch, factory default settings must be restored via a terminal connected to the RS232 control port. See RS232 Control on page 16 for how to restore default settings.
Do not change this field.
Figure 8- Switch Configuration Mode screen
For more on configuring RS232 control, see "RS232 Control" on page 16.
Exit Switch Configuration Mode
Once changes are made to the Switch Configuration menu, press <Enter> and <Y> to save them.
To exit without saving, press <Esc>, then <N>, then <Esc> again. The menu will return to the Administration Mode without saving the changes made. .
Changes made will take effect the next time the NODEMUX is power cycled.
9