Manuals / New Buck Corporation / Household Appliance / Home Security System

New Buck Corporation 81 installation instructions INSTALLATION OF CLOSE CLEARANCE SHIELDS Optional

Models: 81

1 39

Download 39 pages 49.04 Kb

Page 25

INSTALLATION OF CLOSE CLEARANCE

SHIELDS (Optional)

1.Take rear close clearance shield and center with back of stove using self-tapping screws.

2.Remove self-tapping screws from rear of stove. Align holes in side shield with holes in rear shield and attach to stove.

3.Before tightening the screws, insert the front end of the shield behind the side angle on the front side of the stove. Use the same step to install side shield on the opposite side of the stove.

4.Loosen two top screws holding side shield at rear top. Insert pipe shield where back shield and top rear side shield meets. Tighten screws.

23

Image 25

New Buck Corporation 81 installation instructions INSTALLATION OF CLOSE CLEARANCE SHIELDS Optional

Contents

BUCK STOVE NON-CATALYTICUNIT MODELPage TABLE OF CONTENTS Page MAINTENANCE INSTRUCTIONS MODEL INSTALLATION, OPERATION, ANDREAD THIS FIRST IMPORTANT INSTRUCTIONSINTRODUCTION SECTIONMODEL SECTION MASONRY INSERT INSTALLATIONK* FACTORS OF ALTERNATE MATERIALS MINIMUM CLEARANCESMaterial Required ThicknessINSTALLATION PREPARATION FIREPLACE POSSIBLE TOOLS NEEDED FOR INSTALLATIONMounting the Trim Panels Installation Procedure Positioning the HeaterPage Final Check 5.Check for smoke leaks around the doors SECTION PRE-FABINSERT INSTALLATION PREPARING THE STOVE FOR INSTALLATION SECTION RESIDENTIAL FREESTANDING INSTALLATIONMINIMUM CLEARANCE TO COMBUSTIBLE MATERIAL K* FACTORS OF ALTERNATE MATERIALS ALTERNATE FLOOR PROTECTORS MATERIALMaterial Required ThicknessDETERMINING THE CHIMNEY LOCATION ChimneyB.Wall Exit Into Metal Tee-Box C. Wall Exit Into Masonry Using Single Wall Pipe D. Ceiling Exit-CloseClearance ALCOVE INSTALLATION CLEARANCES FINAL CHECK MINIMUM CLEARANCES TO COMBUSTIBLES FREESTANDING CLEARANCES FOR MODELCLEARANCES FOR MODEL INSTALLATION OF CLOSE CLEARANCE SHIELDS Optional FOR MINIMUM CLEARANCES SEE PAGE FLOOR PROTECTION FREESTANDING MOBILE HOME INSTALLATIONCHIMNEY SECTIONPREPARING THE HEATER FOR INSTALLATION TOOLS FOR INSTALLATIONWARNING DO NOT INSTALL IN A SLEEPING ROOM PREPARING THE ROOM HEATER LOCATION5.Next, remove the four 4 screws holding the heater to the stand. Position heater out of the way of the installation area Ceiling Exit Using Close Clearance Listed Chimney FINAL CHECK SECTION WOOD HEATER SAFETY SECTION OPERATION BUILDING A FIRE ROOM AIR BLOWER OPERATION PROBLEM TROUBLESHOOTINGSOLUTION POSSIBLE CAUSEMODEL WOOD STOVE EPA COMPLIANCE STATUSREPLACEMENT PARTS FOR THE MODEL PROCEDURE WARRANTY TIME PERIODSPRODUCTS COVERED PRODUCTS NOT COVEREDOTHER RIGHTS CONDITIONS AND EXCLUSIONS