INSTALLATION OF MODEL FP - BR10- ZC WITH OPTIONAL WOODEN MANTEL
(1)When choosing the right location for your heater and mantel keep the following in mind:
NOTE: Due to high temperatures, this heater should be located out of traffic and away from furniture and draperies.
NOTE: Kit No. (PA KDMH10) Deluxe Wooden Mantel for
NOTE: See page 18 for “Gas Pressure Check”.
(2)Screen(s) can not be removed or altered (Position screen(s) in the closed position before leaving heater unattended).
(3)Follow instructions for assembly of (Optional) Wooden Mantel. See instructions supplied with mantel.
(4)After mantel has been assembled, slide the heater from the rear into the opening of the mantel.
NOTE: Place a cloth or blanket over the front portions of the mantel as not to scar the wood.
(5)Center the heater in the opening of the mantel. See Figure 6.
(6)Fasten mantel to hearth by using ½" wood screws.
(7)Insert the nine (9) ½" wood screws provided with mantel through slots on nailing flange and secure in place. See Figure 6.
(8)Position mantel and fireplace into desired location.
(9)To light the heater, see “Lighting Instructions” pages 19 through 30. Make sure you have the right gas valve for Natural or LP gas.
NOTE: Hook gas supply line into heater. Check for leaks using soap and water, not an open flame.
NOTE: When used as a bedroom fireplace, the unit must be attached to the wall. Use the angle provided with the mantel. Also the safety screen must be kept mechanically secured to the unit as it is when it leaves the manufacturer.
Page 11
