New Buck Corporation FP-BR-10-ZC manual Depleted gas supply

			5.	Depleted gas supply						5.	Contact local propane
											gas company
			6.	ODS/Pilot is clogged						6.	Clean ODS/Pilot or
											replace ODS/Pilot
											assembly
			7.	Gas regulator setting is not						7.	Replace gas regulator
				correct
3. ODS/Pilot	lights	but	1.	Control knob is not fully						1.	Press control knob
flame goes	out	when		pressed in							completely
control knob is released			2.	Control		knob not		pressed		2.	After ODS/Pilot lights
				in long enough							keep control knob
											pressed 30 seconds
			3.	Safety		interlock		system		3.	Wait 1 (one) minute for
				has	been		triggered		(if		safety interlock system
				equipped)							to reset
			4.	Manual		shutoff valve			not	4.	Fully open manual
				fully open							shutoff valve
			5.	Thermo-couple connection						5.	Hand tighten until snug,
				loose at control valve							then tighten 1/4 turn
			6.	Pilot	flame		not	touching		6.	Contact local propane
				thermo-couple,				which			gas company. Clean
				allows thermo-couple to							ODS/Pilot (See
				cool causing pilot flame to							“Cleaning and
				go out. This problem can							Maintenance”), or
				be caused by one or both							replace ODS/Pilot
				of the following:							assembly

A)low gas pressure

B)dirty or partially clogged ODS/Pilot

7. Control valve damaged 7. Replace valve control

4. Burner does not light after 1. Burner orifice is clogged ODS/Pilot is lit

2. Inlet gas pressure is too low

1.Clean burner (See “Cleaning and Maintenance”) or replace burner orifice

2.Contact local propane gas company

5. Delayed ignition of burner	1.	Manifold pressure is too
		low
	2.	Burner orifice is clogged

1.Contact local propane gas company

2.Clean burner (“See Cleaning and Mainten- ance”) or replace burner orifice

Page 29