DRAINING THE UNIT
During the cooling process, some water will be extracted from the air and stored within the unit’s water reservoir.
If the water reservoir is full, both the compressor and motor will stop and the unit will beep (press any button to stop the beeping sound). The full water tank indicator light will also start flashing.
To resume cooling, empty the reservoir by following these steps:
1.Turn off the air conditioner and unplug it from the wall socket. To prevent water leakage, avoid moving the unit
when full.
2. | Place a container (such as a small pan) |
| |
| underneath the drainage hole. |
| |
3. | Remove the drain knob and rubber |
| |
| plug from the drainage hole and allow |
| |
| the water to drain out. |
| |
4. | When the container is almost full, place |
| |
| the rubber plug back into the drainage |
| |
| hole, empty the container, and place |
| |
| the drain knob back over the rubber |
| |
| plug. |
| |
5. | Repeat these steps until the water |
| |
| reservoir is completely empty. | FIG.16 | |
6. | Replace the rubber plug and make | ||
|
sure it is firmly in place.
7.Turn the unit back on. The full tank indicator light should now turn off.
10