Heater Installation
HEATER LOCATION AND CLEARANCES
The heater is intended for use located on a hard floor, table top, desk or on shelf, and the like, or suspended on a wall or ceiling by means of provided hanger bracket.
When suspended from wall or ceiling heater should be located along outside walls to provide perimeter air circulation.
The discharge air should wipe the walls without blowing directly on them. (Figure 2)
If heater is to be tilted on horizontal axis after mounting - ensure a minimum clearance of
26.5inches (67 cm) between floor and bottom of heater. Also, when mounted to ceiling, ensure a minimum clearance of 3.5 inches (9 cm) from ceiling to top of heater. Ensure the air discharge is parallel to or away from walls.
Installation with wall/ ceiling Hanger Bracket
!NOTE: To prevent personal injury always use a licensed electrician to install new outlets or circuits.
Figure 2
OUTSIDE WALL
The use of the hanger bracket allows the unit to be rotated approx 45 degrees in each direction from centre, when attached to wall and tilted in 45 degrees range while suspended from a wall or ceiling.
!NOTE: The hardware for mounting the hanger bracket to the wall or ceiling is not included.
CAUTION: When turning and/or tilting the heater do not block the exhaust opening.
The following steps are shown in Figure 3.
1.Locate a stud or other suitable support and install hanger bracket on wall or ceiling. Select location so control knob on back of heater will be reached easily.
7
