Chapter 20: Remote Access
Changing the Network Settings on the DVR
For the following steps, use the information that you just wrote down. To access the LAN Menu, select the Advanced button, select Network from the list on the left side of the screen, and then select LAN.
∙You can manually enter the IP address/DNS server information into the DVR by selecting Use the following IP address.
∙IP Address: Change this to the IP Address that you wrote down in the previous section. You will have to enter a zero in front of any numbers that do not have three digits. (Using the example from the last section, the address would be 192.168.000.150 after the necessary zeros are added.)
∙Subnet Mask: This should be set to 255.255.255.000.
∙Default Gateway: Change this to the router’s IP Address (Default Gateway) that you wrote down in the previous section. You will have to enter a zero in front of any numbers that do not have three digits.
∙DNS1: This will be filled in automatically.
∙DNS2: This will be filled in automatically.
Write this information on the Information Log at the end of the manual. Be sure to select Apply and restart the DVR to save all changes.
79
