181
n
Shooting (P, S, A, M)
No photo taken when remote control shutter-release button is pressed:
Replace battery in remote control (0167).
Choose remote control mode (053, 55).
Flash is charging (029).
Time selected for Remote on duration has passed: reselect remote control mode (0131).
Bright light is interfering with remote.
Smudges appear in photographs: Clean front and rear lens elements.
If problem persists, perform
image sensor cleaning (0170).
Date is not imprinted on photos: Image quality set to NEF (RAW) or NEF+JPEG basic (051, 136).
Menu item can not be selected: Some options are not available in all modes.
Shutter-release disabled:
Non-CPU lens is attached: rotate camera mode dial to M (0159).
Mode dial rotated to S after shutter speed of “bulb” or “time” selected in mode M: choose
new shutter speed (069).
Full range of shutter speeds not available: Flash in use (060).
Colors are unnatural:
Adjust white balance to match light source (080).
Adjust Set Picture Control settings (087).
Can not measure white balance: Subject is too dark or too bright (084).
Image can not be selected as source for preset white balance: Image was not created with D3000 (086).
Effects of Picture Control differ from image to image: A (auto) is selected for sharpening, contrast, or
saturation.
For consistent results over a series of photos, choose another setting (089).
Can not adjust contrast for selected Picture Control: Active D-Lighting is on. Turn Active D-Lighting off
before adjusting contrast (064).
Metering can not be changed: Autoexposure lock is in effect (075).
Exposure compensation can not be used: Choose mode P, S, or A (076).
Only one shot taken each time shutter-release button is pressed in continuous shooting mode: Lower built-in
flash (054).
Reddish areas appear in photos or textures are uneven: Reddish areas and uneven textures may appear
in long time-exposures.
Turn noise reduction on when shooting at shutter speeds of “bulb” or
“time” (0122).