❚❚Ending Time-Lapse Photography

To end time-lapse photography before all the photos are taken, highlight Off in the time-lapse photography menu and press J, or press Jbetween frames or immediately after a frame is recorded. A movie will be created from the frames shot to the point where time-lapse photography ended. Note that time- lapse photography will end and no movie will be recorded if the power source is removed or disconnected or the destination memory card is ejected.

❚❚No Photograph

The camera will skip the current frame if it is unable to focus using single-servo autofocus (AF-Sor single-servo autofocus selected for AF-A; note that the camera focuses again before each shot). Shooting will resume with the next frame.

DTime-Lapse Photography

Time-lapse is not available in live view (0 31, 161), at a shutter speed of Aor %(0 58), when bracketing (0 197), High Dynamic Range (HDR, 0 141), multiple exposure (0 211), or interval timer photography (0 217) is active. Note that because shutter speed and the time needed to record the image to the memory card may vary from shot to shot, the interval between a shot being recorded and the start of the next shot may vary. Shooting will not begin if a time-lapse movie can not be recorded at current settings (for example, if the memory card is full, the interval or shooting time is zero, or the interval is longer than the shooting time).

Time-lapse photography may end if camera controls are used or settings are changed or HDMI cable is connected. A movie will be created from the frames shot to the point where time-lapse photography ended.

174