Inserting the Batteries
BIf Turn the camera off, remove the lens cap, and turn the camera on. is displayed
Make sure that the lens cap has been removed, and turn the camera off and then on again.
BRemoving the Batteries
Turn the camera off and be sure that the
BAdditional Precautions Regarding Batteries
• Read and follow the warnings and cautions (Aiii, 126).
• Be sure to read and follow the warnings for the battery on page iii and the section, “The Battery” (A126), before using the battery.
• Do not combine old and new batteries or batteries of different makes or types.
• Batteries with the following defects cannot be used:
Steps First
Batteries with peeling | Batteries with insulation that | Batteries with a flat |
| does not cover the area | negative terminal |
| around the negative terminal |
|
BNote on the
When using
BBattery Type
To improve battery performance, set the Battery type setting (A123) in the setup menu (A103) to match the type of batteries inserted into the camera.
The default setting is the type of battery supplied with purchase. When any other type of battery is used, turn the camera on and change the setting.
CAlkaline Batteries
Performance of alkaline batteries may vary greatly depending on the manufacturer. Choose a reliable brand.
CAlternative Power Sources
To power the camera continuously for extended periods, use an AC Adapter
CPower Saving Function (Auto Off)
If no operations are performed for a while, the monitor will turn off, the camera will enter standby mode, and the
When the
➝Power switch,
In shooting or playback mode, the camera will enter standby mode in about 30 seconds (default setting).
•The time allowed to elapse before the camera enters standby mode can be changed from the
Auto off option (A116) in the setup menu (A103). | 15 |
|