Configuring Wireless LAN Settings from the Camera

Services Wireless

6 Choose the desired method for specifying the camera’s IP address and press d.

When [Configuration] is set to [Auto], camera’s IP

address will be specified automatically.

When [Configuration] is set to [Manual], configure the [IP address], [Subnet mask], [Gateway], [Primary DNS], and [Secondary DNS] settings in order, pressing the shutter-release button to apply each setting.

When configuring [IP address], [Subnet mask], [Gate- way], [Primary DNS], and [Secondary DNS] settings, enter each set of numbers so that they are aligned to the right. Numbers must be entered correctly to properly configure the settings.

When all settings have been configured, “Done” will be displayed.

Configuration

Auto

Manual

IP address

192 . 168 . 001 . 005

Confirm

Back

K

Done

134

lMore on Configuring Network Profiles

Before wireless connection profiles are configured from the camera’s setup menu, network profiles for home wireless LANs can be configured in COOLPIX CONNECT mode when the wireless LAN at home meets the following requirements:

•Connection by any wireless device is allowed.

•MAC address filtering is not enabled.

•Data is encrypted using WEP encryption, or no data encryption is applied.

•IP addresses are acquired automatically (DHCP).