Using COOLPIX CONNECT Services

kMessage Displayed During Transfer

The message shown at right is displayed in the monitor during picture transfer. The antenna icon in the top left corner of the monitor indicates signal strength (5-levels). The icon changes to red when outside the network area. When signal strength is poor, remove any obstacles between the camera antenna and access point. To cancel the current transfer, press d.

I 11MB:Available Transferring images

to server.

0 0 2 / 0 0 4

Cancel

kWireless LAN LED

The wireless LAN LED (c 6) is located on the side of the camera (inside the antenna). The camera is searching for profiles when the LED blinks, a wireless connection is established when the LED is lit, and the camera is disconnected from a wireless LAN when the LED is off. If transfer is not performed for a while, the LED may blink to save power.

kThe Memory Card Write-Protect Switch

When the memory card write-protect switch is in the “lock” position, transfer cannot be per- formed. Unlock by sliding the switch to the “write” position before transferring pictures.

kWhen the Transfer is Unsuccessful

When transfer is unsuccessful over a wireless LAN connection, the next time you attempt transfer, the confirmation dialog shown at right will be displayed. If necessary, you can change profiles from the confirmation dialog. Complete transfer, making sure that it was successful.

This confirmation dialog will not be displayed when upload of all pictures using Picture Bank is initiated by connecting the AC adapter (c 150).

K

Resume interrupted transfer?

No

Yes

Change SSID

Services Wireless

145