INSTALLATION
Installing the Security Bracket and Cable
1.With the loudspeaker in the proper location, turn the loudspeaker over so the bottom of the loudspeaker is facing you, as shown in Figure 7.
2.Take the nylon security cable, supplied with the loudspeaker and fold it in half.
Using the middle of the cable, feed it through the Security Attachment Eyelet as shown in Figure 8.
Figure 7 Bottom of Loudspeaker | Figure 8 Security Cable in Eyelet |
3.Feed the opposite end of the nylon security cable through the exposed portion
of the cable that was just fed through the security eyelet, as shown in Figures 9 and 10.
Figure 9 Security Cable
Looping Through
Figure 11 Security Cable Connected and Tightened
Figure 10 Security Cable after Looping
4.Pull the ends of the security cable with the loops as tight as you can until the
knot around the security eyelet is tightened as shown in Figure 11.
5.Feed the Security Stake through the loops at the end of the security cable and insure that they are inserted into the
cable holder provided at the top of the stake, as shown in Figure 12.
15
