INSTALLATION
6.Loop the end of the aircraft cable around the eyebolt and back to the aircraft cable. Secure this end of the cable to the main aircraft cable with the wire rope clamp.
7.Turn the loudspeaker over and feed the other end of the aircraft cable through the eyelet in the bottom of the loudspeaker.
8.Loop this end of the aircraft cable around the eyelet and back to the aircraft
cable. Secure this end of the cable to the main aircraft cable with the wire rope clamp. The upgraded attachment should now look like Figure 14.
Rock Speaker |
|
Aircraft Cable | Eyelet |
|
Concrete
Anchor
Wire Rope Clamps
Figure 14 Upgraded Security Attachment
Final Adjustments
Now that the loudspeaker’s phase, operation and security is assured, there are some final steps to ensure that the loudspeakers installation is complete and that they are used at there full potential.
1.Cover any trenches or wires that are still open or exposed.
2.Point the loudspeakers per the layout and verify that the sound is even and consistent throughout the area that sound is desired, as you did in step 5 of verifying system operation.
3.Verify that the front of the loudspeaker is as close to perpendicular to the ground as possible. This will aid the drainage of water away from the woofer and improve sound quality.
4.Check that the entire installation is safe and secure.
17
