Niles Audio RS8Si Sandstone manual Upgraded Security Attachment Method Optional, Installation

6.Pick a spot in the ground which the loudspeaker will cover and drive the security

stake all the way into the ground until the cable holder is completely under the surface of the ground, as shown in Figure 13.

Figure 12 Security Stake	Figure 13 Security Stake
Attachment to Cable	Driven into Ground
	7. Pull
	on the security cable and verify that the
	stake is securely held in the ground.

Upgraded Security Attachment Method (Optional)

To perform this attachment method you will need the following items:

1.(1) Stainless Steel Eyebolt

2.(1) Concrete Anchor sized to the Stainless Steel Eyebolt

3.(1) Bag of Quikcrete – fast drying cement mix or equivalent

4.A post hole digger or shovel

5.(1) Stainless Steel Aircraft Cable 1/8" diameter or larger

6.(2) Stainless steel wire rope clamps sized to the aircraft cable chosen

To install an upgraded security system:

1.Prepare a hole that is at least one-foot deep, at a minimum (three-feet if the speaker is being installed in an area that has a frost line). The hole should be at least six inches in diameter. This hole should be under the desired location of the loudspeaker.

2.Once the hole is prepared, mix the concrete per its’ instructions. Fill the hole with concrete. Place the concrete anchor in the center of the concrete so the top of the anchor is flush with the top of the concrete and the anchor is not filled with concrete.

3.Wait until the concrete is dried per the instructions on the concrete mix used.

4.Screw the stainless steel eyebolt into the concrete anchor

5.Feed one end of the stainless steel aircraft cable through the eyebolt in the concrete

INSTALLATION

16