CHECKING PHASE ON THE SATELLITE LOUDSPEAKERS
Loudspeaker wire has two conductors. On applications with satellite loudspeakers, one conductor is attached to a component’s negative
•Stripe on one wire
•Ribbed area you can feel on one conductor
•Different colors of metal wire on each conductor
•Fabric strand or string wound into one of the conductors
Of course, there are some wires that appear completely identical. If wired incorrectly, one satellite loudspeaker will be playing
1.Stand halfway between the satellite loudspeakers.
2.Play some music with the amplifier or receiver set to Mono.
3.Listen to the richness of the bass and the loudness of the sound.
4.Turn off the amplifier and reverse the connections on the SW300 SPEAKER OUT binding post.
5.Repeat the listening test with the same volume control setting. When the sound has a richer bass and is slightly louder, the satellite loudspeakers are working together or
INSTALLING AND REMOVING THE GRILLE
•To install the grille, start with the top two grille posts and gently press the grille frame in at each of the four recessed holes. When properly installed, the grille will be approximately 2 to 3 mm away from the cabinet along the sides.
•To remove the grille, start with the bottom two grille posts and gently pull the grille frame away from the SW300’s edge at each of the four recessed holes. Store the grille in a safe place for future use.
CLEANING
Use a dampened soft cloth or paper towel to clean the cabinet and grille.
16 |
| NILES AUDIO CORPORATION – |
| 17 |
|
|