Niles Audio ZR-8630AVZR-8630AV Terminating FOUR-PAIR Twisted Cable, Connecting Accessory Keypads

CONNECTIONS

TERMINATING FOUR-PAIR TWISTED CABLE

The Select™ and Solo™ Master Keypad Modules, the Expander, and the ZR-8630AV unit’s system-expansion con- nections require a four-pair twisted cable with a one-to-one wiring configuration. To maintain consistency throughout all IntelliPad® Ci installations, we recommend the color-coding pattern described in Figure 31, but you may adopt a different color-coding pattern if you use it consistently throughout the system. IMPORTANT: use VW-1 rated wire for connection to KEYPADS and 12V OUT terminals.

1 = Green/White

2 = Green

3 = Orange/White

4= Blue

5= Blue/White

6= Orange

7= Brown/White

8= Brown

Pair 2

Pair 3			Pair 1			Pair 4
1	2	3	4	5	6	7	8
			T568A

Figure 31

Figure 32

CONNECTING THE MASTER KEYPADS TO THE HOME RUN OF FOUR-PAIR TWISTED CABLE

Terminate the home run of four-pair twisted cable with a male RJ-45 connector. Plug it into the rear-panel SYSTEM jack on the Select™, Select™ IR, Solo™, or Solo™ IR Master Keypad Module (see Figure 32).

RJ-45 Connector for

connection to the ZR-8630AV

CONNECTING ACCESSORY KEYPADS

Jumper cables (included) mate each Master Keypad Module with an optional Accessory Keypad Module. (See Figure 33.) The Select™ Master Keypad Module mates with both accessory modules; the Solo™ mates only with the Numeric™.

RJ-45 Connector for connection to IR Sensors

RJ-45 Connector for connection to Numeric™ Accessory Keypad Module

		INPUT	INPUT
IR SENSOR SYSTEM
	ACCESSORY	OUTPUT	OUTPUT
	KEYPADS

Included	RJ-45 Connector
Jumper Cable	for connection to Master
	Keypad Module	Transport™
Select™	Numeric™
Master	Accessory	Accessory
Keypad Module	Keypad Module	Keypad Module

Figure 33

47