Nlynx Wireless Gateway manual Access Control

MAC address is 0080C82F8086, which may also be written as 0080c82f8086, 0080C8 2F8086, or 00 80 C8 2F 80 86. The first step in creating a User List entry is to click in the MAC Address input box and type the station's MAC address, with or without spaces.

The Wireless Access control is for specifying whether the wireless station with the specified MAC address will be allowed access or not. Click Yes to allow access, No to deny it.

The Add button stores the MAC Address and Wireless Access controls' settings in the Wireless Gateway's non-volatile memory.

The Delete button is used in conjunction with the drop-down list box next to it. (Note that in some browsers, the list box appears only if there is at list one entry in the User List.) These two controls are for removing entries from the list. To remove an entry, open the list and click or drag to the unwanted entry; then click Delete.

Access Control

The Access Control section of the Wireless Access panel turns the User List on and off, and controls whether non-listed wireless stations are allowed access or not.

The Enable/Disable control puts the User List into effect (“enables” it) or causes it to be ignored (“disables” it). Click the appropriate setting.

The Other Users Wireless Access control determines whether unlisted wireless stations will be allowed access or not. Clicking Yes allows them access, clicking No denies it.

The Save button stores the settings of the Enable/Disable and Other Users Wireless Access controls in the Wireless Gateway's non-volatile memory. The settings take effect immediately after being saved.

46