Connecting the Mediamaster
Front and Rear panel
Antenna | Slot | ||
for connection of the | for a Conax smart card | ||
satellite antenna |
|
|
|
|
|
| |
|
|
|
|
|
|
|
|
A constant green light indicates that the |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| |
Mediamaster is turned ON. |
|
|
|
|
|
|
|
|
A constant red light indicates standby mode. | DC in |
|
| Digital | audio | TV SCART socket * | ||
| ||||||||
The light flashes red when commands from | for connecting the cable | Digital audio output for connection to the TV | ||||||
the remote control are received. | from the external power |
|
| |||||
The light flashes green during software | supply | connecttion) |
|
| ||||
updates. |
|
|
|
|
|
|
|
|
Connecting the Mediamaster
The box for your Mediamaster should contain the following items:
•the Mediamaster
•a remote control with 2 AAA batteries
•a SCART cable (fully connected; 1.0 m)
•an Introduction Guide
•a separate power supply
Preparing the remote control
•Remove the cover from the battery compartment at the bottom of the remote control.
•Insert the 2 AAA (1.5 V) batteries as shown in the diagram, taking care to observe the + and - markings indicated inside.
•Replace the cover.
Power supply
Remote Control
* The TV SCART Socket
When you connect other devices to this socket, always use a fully connected SCART cable like the one supplied. There are SCART cables available that do not have all the pins connected,
which could reduce picture quality if you were to use them.
GB 5
