Connecting the Mediamaster
Common connections
There are many different types of TV/VCR and other equipment that you can connect to the Mediamaster.
In this section you will see some of the most common ways to con- nect your equipment.
If you have problems with your connections and need help, contact your retailer or Nokia Support.
Connecting to the TV with SCART
•Remove the aerial lead from your TV and connect this to the TV AERIAL input socket on the Mediamaster.
•Connect a SCART cable between the main SCART socket on the TV and the TV SCART socket on the Mediamaster.
•Connect an RF cable from the TV/VCR output on the Mediamaster to the RF input socket on the TV.
•Switch on your TV, plug in and switch on your Mediamaster.
You may need to select the AV ( SCART ) channel on your TV to watch Digital TV. In some cases your TV will automatically se- lect this channel when the Mediamaster is switched on.
Note: The RF lead will need to be connected in order to watch analogue channels ( your old 1,2,3,4,5 )
It is always advisable to consult your TV instruction book.
Connecting to the TV without SCART
• Remove the aerial lead from your TV and connect this to the TV AERIAL input socket on the Mediamaster.
• Connect an RF cable from the TV/VCR output on the Mediamaster to the RF input socket on the TV.
• Switch on your TV, plug in and switch on your Mediamaster.
• Select a programme number on the TV that is not currently used for other TV channels.
• Follow the instructions in your TV manual to tune the TV to pick up the First time installation menu.
RF SCART
• Follow the instructions in your TV manual to store this channel. |
| |
• When the First time installation menu is visible, press the ok |
| |
button on the Mediamaster’s remote control to start the instal- | RF | |
lation procedure. | ||
| ||
If the picture quality is bad you can later change the predefined UHF |
| |
channel 43 to any other figure between 21 and 69. You will also |
| |
have to tune your TV to the same (= the new) channel number. |
| |
Please see RF modulator output channel setting on page 15. |
| |
GB 8 |
|
