Nokia PM 3205 manual Selecting Radio Stations, To use voice commands, To scan for stations

7.To review, change, or delete the voice command, press Options, scroll to select the action, and press Select.

To use voice commands:

Note: To use voice commands to operate the radio, the radio must be on and the phone in the standby mode.

1.From the standby mode, press and hold the key for two seconds. (The key is below Contacts.)

2.Speak your command after the beep. (If a voice match is found, the phone executes the command.)

Selecting Radio Stations

You can use the automatic tuning feature to scan for available local stations, you can program specific stations into your radio, or you can change stations using voice commands.

To scan for stations:

1.From the standby mode, press Menu, scroll to Radio, and press Select.

2.Press Options, scroll to Automatic tuning, and press Select.

3.Press or . (The radio will scan up or down in frequency and stop when the next station with a strong signal is found.)

To program stations:

You can program 20 stations into your radio, then scroll through them to select one for listening.

1.From the standby mode, press Menu, scroll to Radio, and press Select.

2.Press Options, scroll to Manual tuning, and press Select.

3.Press or to select the frequency of a radio station and press OK.

4.Press Options, scroll to Save channel, press Select, enter a name for the channel, and press OK.

5.Scroll to a channel position and press Select to assign the channel to this location.

6.To program more channels, repeat Steps 2–5 until finished with your programming.

Section 2K: Additional Features 120