5.With the help of a second person, set the con- sole assembly on the Uprights (85). Make sure that no wires are pinched. Attach the console assembly with four Console Bolts (72) and four Star Washers (67). Start all four Console Bolts before tightening any of them.
6.Press the Latch Insert (77) into the right side of the left Upright (85), and press the Knob Insert (92) into the left side of the left Upright. Use a rubber mallet, if necessary.
Remove the latch knob from the latch pin. Make sure that the collar and the spring are on the pin. Next, insert the pin into the Latch Insert (77), and tighten the knob back onto the pin.
5 | Console |
| |
| Assembly |
67 | 67 |
72 | 72 |
85 | 85 |
6 |
|
Knob 
77
92Spring
Collar
85 | Latch Pin |
7.Make sure that all parts are properly tightened before you use the treadmill. Keep the included hex key in a secure place. The hex key is used to adjust the walking belt (see page 23). To protect the floor or car- pet from damage, place a mat under the treadmill.
If you purchase the optional chest pulse sensor (see page 19), follow the steps below to install the re- ceiver included with the chest pulse sensor.
1. Make sure that the power cord is unplugged. |
|
| |
Remove the indicated 3/4" Screw (7) and the |
|
| |
Access Door (95) from the left side of the |
|
| |
Console Base (98). | 98 | Wire | |
|
| ||
2. Connect the wire on the receiver (A) to the indi- |
| Small | |
cated wire extending from the Console Base |
| ||
| Screws | ||
(98). Hold the receiver so the small cylinder is |
| ||
|
| ||
oriented as shown and is facing the Console |
|
| |
Base. Attach the receiver to the plastic posts on | 95 |
| |
the Access Door (95) with the two included small |
|
| |
screws. |
| A | |
|
| ||
3. Make sure that no wires are pinched. |
| Small | |
7 | Cylinder | ||
Reattach the Access Door (95) with the 3/4" | |||
|
| ||
Screw (7). Discard the other wires included with |
|
| |
the receiver. |
|
| |
| 8 |
|
