12.Apply a generous amount of grease to the axle on the Right Upper Body Leg (72). Then, apply grease to a Large Wave Washer (89).
Slide an Upper Body Leg Spacer (9) and a Large Wave Washer (89) onto the Right Upper Body Leg (72). Make sure that the flat side of the Upper Body Leg Spacer is facing out- ward.
At the same time, slide the right Pedal Arm (32) onto the Right Upper Body Leg (72) and insert the right Link Arm (30) into the right Link Arm Bracket (45).
Apply a small amount of grease to an M10 x 58mm Shoulder Bolt (104) and to the right Link Arm Bracket (45). Attach the Link Arm (30) to the Link Arm Bracket with the Shoulder Bolt, an M8 x 23mm Washer (31) and an M8 Nylon Locknut (94).
Then, attach the Pedal Arm (32) to the Right Upper Body Leg (72) with an M8 x 23mm Shoulder Screw (105), an M8 Washer (106), an Axle Cover (66), and an M8 x 23mm Thin Washer (96).
Repeat this step for the left Pedal Arm (32) and the left Link Arm (not shown).
See step 4. Tighten the M8 x 19mm Patch Screws (86).
13.Tighten an Adjustment Knob (52) onto an Adjustment Pin (101).
Repeat this step for the other Adjustment Knob (not shown) and the other Adjustment Pin (not shown).
12 |
|
72 |
|
32 |
|
Grease |
|
9 |
|
89 |
|
Grease |
|
96 |
|
| 106 |
32 | 105 |
66 |
|
104 |
|
45 |
|
Grease |
|
31 |
|
30 |
|
94 |
|
13 |
|
52 |
|
101 |
|
14.Make sure that all parts of the elliptical exerciser are properly tightened. Note: Some hardware may be left over after assembly is completed. To protect the floor or carpet from damage, place a mat under the ellip- tical exerciser.
11
