Toshiba TF 461 manual Adjust alignment, 83 GB, Scheme, Press Stop to return to the standby mode

Configuration of the printer

Adjust alignment

In the bi-directional print mode (see page 49 for setting the function {function 68}), the printhead operates in both directions. It is particularly difficult for the printhead to print vertical lines in this mode. If vertical lines are therefore not completely straight, you can adjust the alignment of the printhead as follows:

Scheme:

Right correction necessary:

Left correction necessary:

Optimum alignment:

FUNCTION

PROGRAM SETUP DATA REDIAL

3x

PAUSE

PRINTER SETUP

START

REDIAL

3x

PAUSE BIDIRECT. ALIGNMENT

Open the TF 461 as if you wanted to replace the printer cardridge. Ensure that the inside of the machine is well lit (use a torch).

To start the menu

Page through the menu...

...until you reach the desired menu item

Confirm with START

Page through the menu...

...until you reach the desired menu item

Confirm with START

START

ADJUST ALIGNMENT

STOP

15-03 19:56 M 100%

Please wait until the page has been drawn into the machine and the initial printing process has been completed (this will take some time)...

Now look at the section which has just been printed in your TF 461. A number of vertical lines has been printed. If you can see that the lines are not perfectly straight, you can adjust the machine using the following buttons:

*- Button = Left correction

# - Button = Right correction

A test printout is made after every adjustment. Check the new result, and repeat the correction if necessary.

When the printed lines are perfectly straight:

Press STOP to return to the standby mode

TF 461 TOSHIBA Configuration of the printer 83 GB