Woods Equipment M8200 manual Hydraulic Installation, #56038 Valve Kit & #46047 Hose Kit Cont’d

3

#56038 Valve Kit & #46047 Hose Kit Cont’d

Attach Control Cables to Valve

1. Thread jam nut (g) over threaded end of cable.

2. Slide retainer (f) over cable.

3. Thread adjuster (e) completely over cable.

4. Thread jam nut (d) onto cable.

5. Thread cable adapter (a) onto end of cable. Adapter should be installed so that three threads on the cable remain visible at the jam nut.

6.Remove screws from retainer (c) while keeping

retainer in place.

7. Attach adapter (a) to the valve spool using pin (b). Thread adjuster (e) onto cable to hold pin (b) in place.

8.Install socket head cap screws (h) through the assembly (c-f). Leave retainer (f) just loose enough to

allow adjuster (e) to be turned.

NOTE: Valve cable connect kit contains three sets of socket head cap screws. Use 3/4” long screws for all sections.

9. Turn the adjuster to remove all slack from the cable housing and to keep the control lever centered.

BUCKET

BOOM

a

b

c

CD5816

d

e

f

g

h

AUXILIARY (OPTIONAL)

		Figure 29 Control Cable Assembly
Adjust Control Cable
1.	Check control lever operation before starting trac-	6. Loosen the adapter jam nut (d) and turn the cable
tor. Lever should be centered and movement should		adapter until movement is correct (lengthen cable by
be equal in all directions except “float” position. Float		turning 2 or 3 times).
position is locked forward.		7. Reconnect the cable adapter (a) and repeat cable
2.	If the lever movement is not equal or the “float”	adjustment procedure (Steps 1-4).
position cannot be engaged, adjust the cables as fol-		8. When adjustment is complete, tighten jam nut (g)
lows (refer to Figure 29):
		and retainer cap screws (h) securely to hold cable
3.	Loosen the adjuster jam nut (g) and the retainer	housing in place, but do not overtighten.
cap screws (h) slightly so that adjuster (e) can be		9. Torque cap screws to 10 lbs.-ft.
turned by hand.
		10. Use a plastic tie strap to secure the cables to the
4.	Rotate the adjust to move the control lever to cen-
		loader mount.
ter position.
5.	If the lever cannot be adjusted for correct opera-
tion, remove the adjuster (e) and disconnect the cable
adapter (a) from the valve.

PN-46018 (Rev. 3/15/02)

Hydraulic Installation 25