Woods Equipment M8200 manual Install Controller Stand Bracket, Assembled Control Stand Bracket

3

#56038 Valve Kit & #46047 Hose Kit Cont’d

Install Controller Stand Bracket

NOTE: Use #46049 adapter plate and hardware from #46047 Hose Kit.

1.Locate the control cable access hole under the rubber floor mat in the right front corner of the tractor cab.

2.Insert three carriage bolts (2) into the adapter plate (1) as shown in Figure 26.

3.Position the adapter plate over the holes in the cab floor and install cap screws (6) and lock washers

(7) as shown in Figure 26. Torque to specifications given.

NOTE: Before tightening three cap screws, verify that the fourth cap screw will line up with the hole in the cab floor.

4.Install controller mount bracket on top of ￿￿￿￿￿￿the pre installed carriage bolts and fasten with lock washers

(3) and nuts (4) as shown in Figure 25.

5.Install fourth cap screw as shown in Figure 26.

6.Torque all hardware to specifications given.

7.Trim the rubber floor mat and foam padding to fit around the adapter plate.

￿ ￿	￿ ￿ ￿	$'$37(5
		3/$7(
Figure 25 Assembled Control Stand Bracket

723 9,(:	￿WK &DS
&DS	6FUHZ
6FUHZV	&DUULDJH
￿￿￿
	%ROW
		￿	￿
&DUULDJH
%ROWV
￿	￿	￿
￿
￿￿￿￿￿￿￿&$%			￿
)/225

Figure 26 Control Stand Bracket

1.46049 Adapter plate

2.20973 3/8 NC x 1-1/4 Carriage bolt

3.838 3/8 Lock washer

4.835 3/8 NC Hex nut

5.56215 Controller mount bracket

6.307129 M8 x 1.25 x 30mm Cap screw

7.2472 5/16 Lock washer

TORQUE SPECIFICATIONS

	Wrench
Bolt	Size	Required Torque
M8 x 1.25	13mm	15 lbs.-ft.(20 N-m)
3/8 NC x 1.5	9/16”	35 lbs.-ft.(47 N-m)

PN-46018 (Rev. 3/15/02)

Hydraulic Installation 23