3
#56038 Valve Kit & #46047 Hose Kit Cont’d
Install IN & PBY Lines
1.If not done during installation of right rear loader mount, remove the tractor hydraulic line connector tube or adapter block (if equipped) as shown in Figure 2, Page 7.
NOTE: If
2.Remove plastic cap from tractor hydraulic line.
3.Refer to Figure 30. Route hose (3) from valve IN port outside the loader mount to elbow (1) installed to the engine end of the hydraulic line as shown in Fig- ure 32.
4.Refer to Figure 30. Route the hose (3) from valve PBY port outside the loader mount to elbow (1) installed in the transmission end of the hydraulic line as shown in Figure 32.
1.40549 1/2 NPTM x M26 x 1.5M 90° Elbow
2.315038 1/2 NPTF x 3/4 JICM Adapter
3.46046 38” Hoses
72 /2$'(5 9$/9( | |||
,1 3257 |
| ||
|
| ||
| (1*,1( (1' |
| |
| |||
)520 /2$'(5 9$/9( |
| ||
|
| ||
3%< 3257 |
|
|
|
75$160,66,21 (1' |
|
|
|
Figure 32 Tractor PBY & IN Connections
Hydraulic Installation 27