Woods Equipment M8200 manual Mount Installation, LOADER MOUNT INSTALLATION Cont’d, 02817, 526600%5

LOADER MOUNT INSTALLATION Cont’d

Install Crossmember

NOTE: Leave all cap screws loose until loader mounts are completely installed.

1.Install #46000 crossmember to the underside of the tractor clutch housing, using cap screws and hardened flat washers as shown in Figure 4.

1.307502 M18 x 1.5 x 85mm Cap screw

2.57798 3/4 Hardened flat washer

3.67376 M12 x 1.25 x 80mm Cap screw

4.57816 1/2 Hardened flat washer

&52660(0%(5

￿ ￿ ￿ ￿

Figure 4 Crossmember Installed

Install Rear Loader Mounts

1.Install #44490 right rear mount and #44491 left rear mount to tractor chassis and crossmember.

NOTE: Non-cab tractors will need #46015 spacer plate installed between the rear mounts and the trac- tor.

2.Use cap screws (1) and hardened flat washers (2) at tractor clutch housing as shown in Figure 5.

3.Use cap screws (3) and hardened flat washers (4) to attach mount to crossmember.

1.46019 M18 x 1.5 x 70mm Cap screw

2.57798 3/4 Hardened flat washer

3.12274 5/8 x 2-1/4 Cap screw

4.57817 5/8 Hardened flat washer (hidden)

6.230 5/8 Hex nut (hidden)

		/2$'(5
		02817
￿	￿
	￿￿￿￿￿￿		￿	￿
		&52660(0%(5	￿	￿

Figure 5 Left Rear Mount Installed

8 Mount Installation

PN-46018 (Rev. 3/15/02)