Woods Equipment M8200 manual Hydraulic Installation, #56038 Valve Kit & #46047 Hose Kit Cont’d

3

#56038 Valve Kit & #46047 Hose Kit Cont’d

IMPORTANT

■If hydraulic lines are not connected as shown in he mounting kit manual or the tractor manual, the control valve my be damaged. A blocked outlet return) or improper hose connection will cause pressurized oil to enter the return circuit and dam- age the valve or the tractor hydraulic system.

■Use care when identifying valve ports. Cable operated loader valve is mounted in the inverted position (stems down as shown in Figure 33.)

■If tractor hydraulic system pressure is greater han 2650 psi, make sure the valve used is equipped with a relief valve.

5

6

PBY

7

6

8IN

OUT

1

2

1

5

CD5618C-Var

Figure 30 #46047 Hose Kit

Install OUT Line

1.Connect 90-degree end of 100” hose (3) to adapter in valve OUT port. Refer to Figure 30.

2.Route hose under fuel tank, then over right rear axle to tractor Return port (above the upper right of the PTO shield) and connect. Use straight adapter (1) and 90-degree elbow (2) as shown in Figure 31.

1.315058 1/2 NPTM x 3/4 JICF Adapter

2.313032 3/4 JICM x 3/4 JICF 90° Elbow

3.46044 100” Hose

75$&725

5(7851

3257

￿	￿	￿￿￿￿￿￿
￿
	Figure 31 Tractor Return (OUT) Port

26 Hydraulic Installation

PN-46018 (Rev. 3/15/02)