LOADER MOUNT INSTALLATION Cont’d
Remove Tractor Connector Tube or Adapter Block
Follow this procedure only if using #40547 or #46047 Hose Kits.
NOTE: It is easier to remove the connector tube or adapter block before installing the right mount.
1.Remove tractor hydraulic line connector tube or adapter block (if equipped) as shown in Figure 2.
2.To prevent the line from leaking during installation of the loader mounts, be sure to plug the fitting. A 3/4” plastic cap taken from an adapter in the hose kit may be used.
(1*,1( (1'
| /,1( | |
| &$33(' |
|
|
|
|
|
|
|
Figure 2 Hydraulic connector Tube Removed (Rear line capped with 3/4” plastic cap)
RH Rear Mount 44490
Spacer
Plate
46015
Spacer
Plate 46015
| Crossmember | LH Rear Mount | |
| 44491 | ||
RH Side Rail | 46000 | ||
| |||
59628 |
|
|
Grill Guard 1000545
|
| Loader | |
Front Support | LH Side Rail | Mounting | |
Instruction | |||
1002896 | 59631 | ||
Decal | |||
|
| ||
|
| 56059 | |
|
|
Figure 3 111868 Loader Mounting Kit