Runco VX-33D operation manual Installing and Adjusting the CineWide Anamorphic Lens

Installation

If you are installing a VX-33d/CineWide or VX-33d/CineWide with AutoScope, proceed as follows to install and adjust the anamorphic lens.

It is extremely important that the primary lens is properly

Note adjusted before you install the anamorphic lens. Ensure that the image from the primary lens is perfectly centered on the screen.

3.11 Installing and Adjusting the CineWide Anamorphic Lens

The VX-33d Anamorphic lens mount kit consists of everything shown in Figure 3-19.Some components shipped with your projector may differ slightly from what is shown in these instructions. If any items are missing or damaged, please contact your Runco dealer or Runco Customer Service at (800) 23-RUNCO.

1Lens Adapter Ring and Mounting Screws (3x)

10 Anamorphic Lens

Set Screw

9Pitch Adjustment T-Nut (2x)

2 Pitch Adjustment Yoke for Lens

3 Height/Y Adjustment

T-Screw and Washer

(2x)

4 Pitch Adjustment

T-Screw and

Washer (2x)

5 Anamorphic Lens

Holder

8 Yaw/X Adjustment

Lever (2x)

6 1/4-20 Hex Bolt (2x)

and Washer (2x)

7 AutoScope Carriage Plate or Fixed CineWide Base Plate

Attach Lens Mounting Assembly to Lens Motor Carriage Plate (CineWide with AutoScope) or Base Plate (fixed CineWide)

Figure 3-19. VX-33d Anamorphic Lens Mounting Assembly - Exploded View

1.Remove the two Yaw/X Adjustment Levers (item #8) from the bottom of the Anamorphic Lens Holder (item #5).

Runco VX-33d Installation/Operation Manual 41